Motorsil D original red silicone gasket - Arexons 0096

Self-leveling

Product for seals, forms a gasket of any thickness.

Allows dynamic and elastic couplings to be formed.

Fills microspaces due to imperfect flatness, replacing all types of preformed gaskets.

Self-leveling, hardens without loss of volume.

Cross-links at room temperature by the action of moisture.

Employment

As a replacement or adjuvant for any type of preformed gasket.

Also suitable for engines equipped with catalytic converters; since it is a low-volatility product, there is no risk of impairing the operation of the lambda sensor.

Easy to remove.

The product, after cross-linking, resists water, fuels*, mineral and synthetic oils, radiator fluids.

*Gasoline: resists only vapors, exhibits poor resistance in immersion, however.

Use

Use on clean and degreased surfaces.

Proceed with assembly of parts after about 20 minutes (skin formation).

Crosslinking can be accelerated by heat.

Warnings

Excess fresh sealant can be removed with a rag possibly soaked in solvents, while, after curing only by mechanical means.

Traces of acetic acid vapors take place during curing.

Avoid prolonged contact of the product with the skin and eyes; in case of contact with the eyes, wash thoroughly with water.

Storage

Validity of product after packing in sealed package and stored at room temperature: 24 months minimum.

Technical characteristics

Base: single-component self-leveling silane

Color: red

Cross-linking: acetic

Application temperature: +5 ÷ +40°C

Viscosity: 250,000 cPs

Specific gravity: 1.120 g/ml

Skin time: 10 minutes

Cure rate: 4.5 mm/day

Volatile: 3% approx.

Characteristics when fully cured

Shore A hardness: 50

Operating temperature: -70 to +250°C 300°C for short periods

Tensile strength: 4.5 MPa

Elongation at break: 200%

Modulus of elasticity (100% elongation): 1.8 MPa

DCR (strain remaining at compression): 35%

60gr aluminum tube.